Panasonic CT-36VG50 - Manual (Page 15)

Special Functions
MULTI Button
The MULTI button can be programmed to issue
several commands at the same time.
Example: TV Power/On, VCR Power/On, and
Cable Box Power/On.
Procedure:
1. Enter proper infrared codes for all devices
before programming. See code section.
2. Point your Remote Control transmitter away
from all equipment remote sensors, then:
Press and
keep holding
then ALSO
Press and keep
holding f o r 3
seconds
Release after 3
seconds
NOTE: Waiting more than 30 seconds without
pressing another button will exit the
programming mode.
3. Press a maximum of 6 function buttons on the
Remote Control.
Each button you press is equal to one function.
If 6 Remote button functions are entered, all will
register in the C mu T t O button memory when the
sequence is entered. When finished, press the
C>M~Tt>to exit the programming mode.
NOTE: Buttons which continuously perform a
function as long as pressed (Volume Up/Down,
Channel Up/Down, etc.) cannot be programmed:
only those buttons which perform a function
when initially pressed (Power On/Off, Mute,
Direct Channel Entry, etc.) can be
programmed.
The following is a flow chart example of remote
functions that can be programmed into the
0^0 button:
PRESS AT THE SAME TIME
FOR3 SECONDS
PRESS
©
PRESS TO EXrr
PROGRAMMING MODE
Pressing the button will now activate the
VCR Power/On, Cable Box Power/On, and the
Receiver Power/On at the same time.
RECALL Button
Press the RECALL button to review:
(l) Audio Mode status
@
CH number or Video Input selected
@ Channel Caption (Station Identifier)
(j) Clock time
@ Sleep Timer status
© ©
©
R-TUNE Button
Pressing the R-TUNE (RAPID TUNE) button toggles to
the previously tuned program.
PROGRAM
CURRENTLY VIEW ED
Press Button
PROGRAM
PREVIOUSLY VIEW ED