Amplifier section, O power “standby c!)/on” switch and indicator, Fpower/standby 6/on) – Panasonic SA-HD52 User Manual
Page 9: E headphones jack (phones), 0 remote-control signal receptor (remote sensor), O input selectors (input selector), 0 balance control (balance), 0 volume-level adjustment indicators, O volume control (volume)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
0 Q
Amplifier section
O
Power “STANDBY c!)/ON” switch and indi
cator
fPOWER/STANDBY 6/ON)
This switch switches ON arxj OFF the secondary circuit power
only. The unit is in the “standby” condition when this switch is
set to the STANDBY (!) position. Regardless of the switch
setting, the primary circuit is always “live” as Iwig as the
power cord is connected to an electrical outlet.
•The indicator will illuminate when the unit is in “STANDBY”
condition.
e Headphones jack (PHONES)
0 Remote-control signal receptor
(REMOTE SENSOR)
Receives the signals from the remote-control transmitter.
o Input selectors (INPUT SELECTOR)
These selectors are used to select the sound source to be
heard, such as a phono disc, radio broadcast, etc.
0 Balance control (BALANCE)
This control can be used to adjust the balance of sound heard
from the left and right speaker systems.
0
Volume-level adjustment indicators
One of these indicators flashes continually to indicate when
the sound volume level is being adjusted by using the volume
controls on the remote-control transmitter.
UP
(C>): When increasing the volume level.
DOWN
<<]): When reducing the volume level.
O Volume control (VOLUME)
- 9 -