Panasonic SA-HD52 - Manual (Page 10)

Front Panel Controls and Functions
0 9 0 0
(continued)
Graphic equalizer section
0 Display mode button (DISPLAY MODE)
This button can be used to change any of five types of spec­
trum display modes. (Refer to page 17.)
0 Memory button (MEMORY)
This button is used to program the equalization curve into the
memory.
O Memory mode-select button (MANUAL/FIXED)
This button is used to select the equalization memory mode to
be used.
MANUAL: Select this mode to program a desired curve to the
unit's memory or to retrieve a curve that you have
programmed.
FIXED: Select this mode to retrieve a curve that was orig­
inally pre-programmed to the unit’s memory.
O Equalization mode-select button
(EQ ON/FLAT)
This button is used to switch ^e equalization «)rrection func­
tion "EQ ON" and “FLAT”. Each time a button is pressed, the
mode changes alternately to one or the other of the following
modes.
EQ ON: Select this mode to make an equalization correc­
tion.
FLAT: Select this mode if no equalization correction is
desired.
Note that the "EQ ON” mode is automatically selected if a
preset-memory button or an equalizer level-control button is
pressed vrhile this button is set to the "FLAT" mode.
© Display section
(§) Spectrum/Equalization display
■ Spectrum displays
The 5 types of display can be shown. (Refer to page 17.)
■ Equalization-level display
The amount of correction is displayed by a series of lines
(=) for each sound range (frequency range).
This will be shown for 3 seconds when any of the
operation buttons of graphic equalizer (except the dis­
play mode button) is pressed.
(6) Full range display
This shows the full range level.
© Equalization-mode indicators
EQ ON: Indicates that tiie equalization effect has been
switched ON.
FLAT: Indicates that the equalization effect has been
switched OFF.
-10-