Panasonic SA-HD52 - Manual (Page 17)

Display mode button
SS9
d o o o
■ t t • > - * ' 4 ‘ T
13
^ .■viiS • №• mm;w9l^z
IIIIIIElii
£ %3ooaqaa*
do 013
-M2- -24 [>B10H >o 1/HEAVY
—
>FUT >□ 2/CLEAR
0- =
IS5 5555 SS
-12
[> «EMORY
>□
Oo
3/SOFT
4/VOCAL
> MANUAL >a 5/NATURAL
-12- sss == = as = = = = =r = __ — -
-9
> nXED C>a 6/SUPERBASS
63Hz 160HZ 400Hz ikHt 2.SkHi 6.3kHi l2.SkHl niUlMME
Spectrum display
The following 5 types of dispiay are possibie.
The display can be changed by pressing the display mode button.
0 ] Bar-type display
This display can be used to show the ou^ut strength for each
sound range (frequency range), and to show the output
strength of sound for all ranges (full range) by a bar-type display.
Every time the unit is set to “ON”, this type display will always
appear.
[U Peak-hold display
The peak sound value of each sound range is held on the
display for about two seconds after it occurs.
- z l l i
(D Dot display
C^ly the upper two parts of №e bar display are shown, thus
making the strength of the sound for each sound range even
easier to see.
d] Hustler mode
The peak sound value of each sound range is displayed in
augmented form.
H] Aurora mode
The peak sound value of each sound range is displayed in
inverted form.
-ia '
Note:
If an equalization level-control or the memory-mode selector or a
preset-memory button is pressed during any display other than the
equalization-level
display, the equalization-level display will be
shown for about 3 seconds, after which the former display will
return.
-17-