Antenna connections, Fm antenna, Fm indoor antenna (included) – Panasonic SA-HD52 User Manual
Page 7: Fm outdoor antenna (not included), If fm antenna terminal is as shown below, Am antenna, Am loop antenna (included), When attaching the antenna to the unit, Am outdoor antenna (not included)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Antenna Connections
The indication AM used here
includes both MW and LW.
FM Indoor antenna
-il'-
' AM loop antenna location
AM outdoor antenna
-I
~
—I
5-12m—H
Vinyl-covered
wire
(not included)
Note:
An outdoor antenna should be installed by a
competent technician only.
75-ohm coaxial cable
(not included)
FM antenna
■ FM indoor antenna
(included)
Attach to a wall (using tack or tape) facing in the direction of best
reception.
For best reception sound quality:
An FM outdoor antenna is recommended.
Notes:
•The tack should not contact the internal antenna wire.
•Discwinect this antenna if an FM outdoor antenna is installed.
■ FM outdoor antenna
(not included)
If the FM indoor antenna does not provide satisfactory reception of
FM broadcasts, an outdoor antenna should be used.
The outdoor antenna may be required in a mountainous region, or if
this unit is located inside a reinforced-cono'ete building, etc.
-If FM antenna terminal is as shown below
(X) Remove a rxece of the outer
vinyl sheath from the end.
@ Bundle the shield braid, and
remove a piece of the inner
wnyl
sheath
covering
the
core wire.
@ Ttit the lever back and insert
the core wire and the shield
braid.
® Close the lever and pull the
cable gently to be sure that it
is secured.
30 mm
15 mm
FM ANT
AM antenna
■ AM loop antenna
(included)
Connect tiie AM loop antenna to the Ml antenna terminal, and
attach it to a column, rack or this unit (facing in the direction of best
reception).
Notes;
•If this antenna is not properly installed, AM broadcasts will not be
received.
•Be sure to connect the AM loop antenna even when an outdoor
antenna is used.
Pay attention to the following pointa when attaching the
antenna.
•Do not attach it horizontally (to do so would impair reception).
•Do not attach it dose to power cords, speaker wires or metal
surfaces (to do so would result in noise).
When attaching the antenna to the unit
This type of installation may cause impaired reception or result in
signal noise. If possible, attach the antenna to a rack, a wall, or a
column.
Move the antenna toward the right or left to find the point of best
reception.
■ AM outdoor antenna
(not included)
The outdoor antenna may be required in a mountainous region, or if
this unit is located inside a reinforced-corrcrete building, etc. Use
5-12m (16-40 ft.) of vinyl-covered wire horizontally at tiie window.
- 7 -