Panasonic SA-HD52 - Manual (Page 6)

Connections
©
O OJ
Household AC outlet
l:-®
m
“SPEAKERS” terminals “AUX” terminals
The impedance of any speaker used with №is unit must be 8-16
ohms.
Be sure to connect the striped cords to the negative terminals.
p Connection of speaker cords
© Strip off the outer
covering, and twist the
center conductor.
15 mm Twist
© Tilt the lever back and
insert the cord.
© Close the lever and pull
the cord gently to be
sure that it is secured.
Notes:
•To prevent damage to circuitry, never
short-circuit positive (+) and negative (-)
speaker terminals.
•Be sure to only connect positive (-(-) cords
to positive (-I-) terminals, and negative
(-) cords to negative (-) terminals.
•Connections of speaker cords should be made before con­
necting the AC power supply cord.
e ®
“PHONO” terminals
Connect the turntable which was specially designed for use with
this system, to these terminals.
PHONO
■ “GND" terminal
This terminal is for use with turntables which have a ground wire.
Connect a second tape deck (for playback only) etc.
AUX Second tape deck (not included)
O G-
■iL LINE OUT
ft 1
o 9 R
— ■ ' — 1_1 '
(R) (L) (R) (L)
y
E
7
Stereo connection cable (not included)
AC power supply cord
© Connect this cord only after all other cables have been con­
nected.
Note:
Configuration of the AC outlet and AC power supply cord differ
according to area.
© For United Kingdom
Household
AC outlet
Fit a suitable plug to the AC power
supply cord.
- 6 -