Panasonic PV-GS39 - Manual (Page 45)

p : r ; M o d e
The recorded scene can be played back immediately
after the recording.
• Open the LCD Monitor or extend the Viewfinder
before turning on the power.
1
Set the [OFF/ON] Switch to [ON],
• The [STATUS] Indicator lights Red.
OFF- -ON o
2
Set the Mode Dial to Tape Playback Mode.
• The [ 0 TAPE PLAYBACK MODE] is displayed
on the screen.
• The One-Touch Navigation icon is displayed
on the lower right of the screen.
[One-Touch NavLgatioii icon]
(PV-GS39/ (PV-GS29)
PV-GS59)
3
Move the Joystick Control [^] to rewind
the tape.
I !i ' - 0 s
• Rewind the tape to the point where you want to
start playback.
• When the tape reaches the beginning,
rewinding stops automatically.
Move the Joystick Control [A] to start
playback.
• The [^] Indication appears.
if«™
■
__ I
• If a cassette recorded with copyright protection
signal is played back, the picture is distorted by
mosaic-like patterns.
I To Pause Playback
Move the Joystick Control [A] to select [ * • in ]
during playback.
I To Stop Playback
Move the Joystick Control [T] to select [ I ].
Adjust the speaker volume for playback.
1
Push the [- ffl I VOL +] Lever to adjust the
volume.
• Towards [+]: increases the volume
Towards [-]: decreases the volume
(Nearer the bar to [+]. larger the volume.)
;>
=ii! - iilj ■■
On the Remote Control, press the [T] Button to
increase the volume or the [W] Button to decrease it,
(PV-GS59 Only)
Notes;
• When the ai^ustment is completed, the volume
indication [ n|] will disappear.
• If you do not hear the sound, check the settings of
; S] SETUP] » [ a 12bit AUDIO].
Rc p i;o. i P! ¿i y b c k
When the tape end is reached, the tape will
rewound and played back again.
be
1
Set
[«
ADVANCED]
» [ t)
REPEAT PLAY]
» [ON].
2
Move the Joystick Control [A] to start
playback.
• The [ cL>^] Indication appears.
a To cancel Repeat Playback Mode
Set [ o REPEAT PLAY] » [OFF] or set [OFF/ON]
Switch to [OFF],
• When you set [H USB FUNCTION] » [WEB
CAM] and then connect the USB Cable, the
Repeat Playback Mode is canceled.
Settings on the audio
• If you cannot listen to the desired audio when
playing back a tape, check the settings in
[ Iji SETUP] »[¡112bit AUDIO],
• When you record or dub the audio in [12bit] and
S 6 t [ y SETUP] » [g 12bit AUDIO] » [MIX],
the audio will be played back in stereo sound
regardless of the settings in [ J) AUDIO OUT],
u
><
O'
u
o
S
a
45