Panasonic NVRX33EG - Manual (Page 135)

ENGLISH
Before Requesting Service
Power Source
Symptom Cause Action Page
Movie Camera does not turn on. ' When using Battery as power source:
Attached Battery is discharged.
Attach fuiiy charged Battery.
22
Movie Camera has turned off i
automaticaliy.
► Recording was paused for more than 6
minutes.
Turn in [POWER] Switch to turn Movie
Camera off and then turn it out again to
turn Movie Camera on.
46
Movie Camera quickiy turns off. ' Condensation has formed inside Movie
Camera.
Wait untii condensation has cleared up
(approximately 2 - 3 hours).
116
Cassette
Remaining Tape Time Indication is not
correct.
► Tape length of inserted cassette is not
correctly selected.
Select correct tape length.
30
X-ray inspection was done at airport, i
Did it affect cassettes?
► No, it has no adverse influence.
-
When piaying back stored cassette, i
picture is distorted.
1
► Cassette may have been magnetized by
other equipment.
Unfortunately, there is no remedy.
Store cassettes correctly.
114
► Cassette was stored in unsuitable place. Unfortunately, there is no remedy.
Store cassettes correctly.
114
Recording
Movie Camera is turned on but no
picture appears in Finder.
► Power Save Functions have become
activated.
Hold Movie Camera again in horizontal
position. Or set [APS] on Main Menu [MAIN
MENU] to [OFF]. 68
Recording does not start when I
pressing Recording Start/Stop Button.
"■ Tab of inserted cassette is broken out. Insert cassette with intact tab.
Or cover hole with two layers of adhesive
tape.
32
Date/Time/Title Indication is not i
displayed in Finder. ► Incorrect operation of [DATE/TITLE] and/or
[MENU] Button.
Press [MENU] Button
and set the desired
Date/Time/Title Indication and then, press
[DATE/TITLE] Button so that Date/
Time/Title Indication appears.
40
Date/Time Indication is not displayed >
in Finder.
” Built-in Lithium Battery is discharged. Charge built-in Lithium Battery.
42
Playback
When piaying back from Movie •
Camera to connected TV, no playback
picture is reproduced on TV.
[POWER] Switch of Movie Camera is not
turned out.
Turn [POWER] Switch out and press [VCR/
CAMERA] Button so that [VCR] Lamp
lights. 56
When playing back from Movie 1
Camera to connected TV, playback
picture is distorted or contains noise
bars.
► Tape is loose. Tighten tape. 28
- Video heads are dirty. Clean video heads with optional video head
cleaning cassette.
116
Picture is not in colour. i
1
- Colour adjustment on TV is not made
properly.
Adjust colour control on TV.
-
- Tracking is not adjusted correctly. Adjust tracking correctly. 62
Remote Controller
Remote Controller does not work. i
1
► Button-type battery in Remote Controller is
exhausted.
Replace button-type battery with a
new CR2025 battery.
96
► Strong light fails on Remote Controller and/
or Movie Camera.
Prevent strong light from falling on Remote
Controller and/or Movie Camera.
94
Demonstration Mode
Movie Camera remains in i
Demonstration Mode.
► Demonstration Mode is designed for
explaining the functions of this Movie
Camera.
Turn in [POWER] Switch and then turn it
out again while pressing [STOP] Button. 128
135