Panasonic CF-E1M - Manual (Page 20)

Conserving Power
When your computer is left alone for a while, you can set it to automatically enter the system
standby (hereafter, hibernation mode) or cut the power of the display.
Setting Power Management
1
Select [Start]-[Settings]-[Control Panel]-[Power Management]
2
Select [Power Schemes]
Ponfof Ménageaient Piopeities BSfl
[\ Pt»™ Schsmoî j Advanced j __________ _____
SeieeJ. the pov«r schem the most approptiete settings for
this computer Note that change the below vv4 mipdtfy
the selected scheme.
p Pflwef schemes ^■ 1 '
i3f
rs
i- pSettiiffi lor Horre/Oilicc Desk pow scheme-
p| I System | Never
Tianc^ffflOfKor.
Tun off herd disks:
I After 15 r
[Aitet 30 r
~3-
■0 Click |F| and select the setting
and set the time for each
(D Click [OK]
X note >
Power schemes
Select one from among:
[Home/Officc Desk]
[Portablc/Laptop]
[Always On]
System standby
This function allows your computer to enter the hibernation mode (O’ page 18), if
it is not being used, after the amount of time set has elapsed.
Turn off monitor
This function cuts the power of the display, if the computer is not being used, after
the amount of time set has elapsed. (The power indicator lamp remains lit.)
Turn off hard disks
This function cuts the power of the hard disk, if the computer is not being used,
after the amount of time set has elapsed.
_
The initial values for the power source settings following a change to [Portablc/Laptop] or
[Always On] arc given in the table below.
Item Portablc/Laptop Always On
System standby After 20 minutes Never
Turn ofl'monitor After 15 minutes After 15 minutes
Turn off hard disks After 30 minutes After 1 hour
20