Panasonic CF-E1M - Manual (Page 12)

First-time Operation
Write Down the Product Key Code
Be sure the mark is facing to­
wards the back of the computer.
The Product Key Code is necessary to perform the setup procedure for Win­
dows (C? page 14) after reinstallation (O’ page 57). Write down the alpha­
numeric Product Key Code shown on the “Certificate of Authenticity” lo­
cated on the right side of the computer in the “Customer’s Record” section
(CO page 2),
Connect the keyboard and mouse to the USB ports.
The keyboard and mouse can each be connected to any one of the four ports.
USB compliant devices such as a floppy disk drive and printer can be connected to the
remaining two ports (CO page 28).
X note >
Two Ways of Positioning the Computer (Display)
• When using the stand A \ # When not using the stand
Completely set in place /A \ display is slightly tilted
(open)
Completely set in place
(closed)
Set the stand after powering OFF. Do not use the computer if the stand has not
been set in place completely.
-------------------------------------------------------- ------------ ^
When connecting peripherals other than the keyboard and mouse, connect them
after completing the setup procedure on page 14.
Read the LIMITED USE LICENSE AGREEMENT (o- page 59)
Before removing the seal covering the power terminal connector, read the LIMITED
USE LICENSE AGREEMENT, Removal of this seal indicates agreement to the terms
specified.
Connect the AC cord
Power Terminal Connector
12
AC120 V