Panasonic CF-E1M - Manual (Page 17)

Shutting Down (power off your computer)
When the power switch is pressed, the “Power Button Control Program” activates, auto­
matically performs the Windows shutdown processing, and powers the computer off. If a
software application is open, power off' the computer after saving the data and closing the
application software.
1
Confirm that 0 ; is displayed on the taskbar
Turn your computer off
Press the power switch and hold it for approximately one second until the power indi­
cator turns olT before releasing it.
Your computer will power off automatically (without using the hibernation function).
(In the OFF state, your eomputcr consumes approximately 1.2 W.)
r
Onec the computer is powered off, you must wait at least ten seconds before pow­
ering it on again.
About the Power Button Control Program
On the next occasion, do not press the power switeh (if the power switch is pressed,
this will force the computer to shut down). Perform the “shutdown operation of
Windows” (below),
orp,.
-When 0, is not displayed on the taskbar (the Power Button Control Program is
off)
OFt;
(0 of the Power Button Control Program is displayed when the computer is started up
again.)
-When the display has gone off due to the Power Management Function
OFF,
When 0 is not displayed (shutdow n operation of Windows)
Perform the “Shutdown Windows” operation as follows. If the “Shutdown Win­
dows” operation does not proceed correctly, this may be due to a problem in the
computer or the deletion of system data.
(3)Click [Start]-[Shut Down].
(From the keyboard, you may choose to press down on [ ^ ] , then select
[Shut Down] wdth © or ©•) ^
dl) )|«U wM
Qííandkflí
O intiS WJS mode
Cf>. ij' Cencel
©Confirm that is on the left side of “Shut down”, and then click [OK].
If is not on the left side of “Shut down”, click the characters of “Shut
down” or move the arrow over ^ and click the mouse.
17