Panasonic UF-333 - Manual (Page 111)

Troubleshooting
^
If You Have Any of These Problems
Mode Symptom Action page
During Installation
The display is blinking Battery is completely discharged. This may happen at first
installation. Replace the battery and re-set the clock.
22
122
During Transmission
Document doesn’t
feed/multiple feed
1. Check that your document is free of staples and paper
clips, and that it is not greasy or torn.
2. Check that your document is the right type to send through
a fax machine by consulting the list on ’’Documents You
Cannot Send”. If your document has the characteristics
listed, make a photocopy of your document and send the
copy instead.
3. Check that the document is loaded properly.
4. Adjust the ADF Pressure Plate.
37
38
120
Document jam The information code 031 will appear on the display if the
document becomes jammed.
116
Does not stamp 1. Check if Stamp LED is lit.
2. Check Fax parameter No. 04 and No. 28 settings.
40
33,34
Stamp too light Replace stamp. 123
Transmission Copy
Quality
Vertical lines on the
transmitted document Check own copy quality. If copy is OK, your machine has no
problem, report to receiving party that they have a problem. If
copy is NG, clean the Document Scanning Area.
119
Transmitted document
is blank
1. Make sure the document is set face down.
2. Check own copy quality. If copy is OK, your machine has no
problem, report to receiving party that they have a problem.
If copy is NG, clean the Document Scanning Area.
119
During Reception
No recording paper The information code 010 will appear on the display if the paper
runs out.
16
Recording paper jam The information code 001,002 or 016 will appear on the display
if the paper gets jammed.
115
Recording paper
doesn’t advance into
machine Make sure that there is paper in the Paper Tray. Follow
instructions for loading paper. 16
Recording paper
doesn’t eject after
printing
Check to see if the recording paper is jammed inside of the
machine. 115
Document auto
reduction doesn’t work Check Print Reduction settings. 64
Out of ink The information code 015 will appear on the display if the Print
Cartridge runs out of ink.
121
8
109