Panasonic KX-FP121NZ - Manual (Page 102)

7 dpeijations
i Display message ; { Cause & Remedy
REMOVE DOCUMENT
• The document is jammed. Remove the jammed document {p. 108).
• Attempted to transmit a document lonaer than 600 mm. Press [STOP] to
remove the document. Divide the document into two or more sheets and try
again.
TRANSMIT ERROR
• A transmission error occurred. Try again.
UNIT OVERHEATED
• The unit is too hot. Let the unit cool down.
When a function does not work, check here
before requesting help
General
Problem ...........__:i;;:i ......."*^^^'^'^'‘'^=^-'Caus^&'Remedy................... -r--.
i cannot make and receive calis. • The power cord or telephone line cord is not connected. Check
the connections (p. 24).
The unit does not work. • Disconnect the unit from the telephone line and connect the line to
a known working telephone. If the working telephone operates
properly, contact our service personnel to have the unit repaired.
If the working telephone does not operate properly, contact your
telephone company.
The unit does not ring. • The ringer volume is set to off. Adjust it to a suitable l^v*fel (p. 29).
The unit displays “CHECK PAPER”
though the paper is inserted. • The paper is inserted halfway. Insert it correctly (p. 22, 23) and
press fSTART/SET/COPY) to clear the message.
The other party complains they only
hear a fax tone and cannot talk.
• The FAX ONLY mode is set. Tell them the number Is only used for
faxes or change to another receive mode on your unit (p. 60, 61).
The speakerphone is not working. • Use the speakerphone in a quiet room.
• If you have difficulty hearing the other party, adjust the volume
using ® or (X).
• If parts of your conversation are cut off, you and the other party
spoke at the same time. Speak alternately.
The [REDIAL/PAUSE] button does
not function properly.
• If this button is pressed during dialing, a pause will be inserted. If
pressed immediately after a dial tone is obtained, the last number
dialed will be redialed.
The receive mode does not function
as explained on pages 60 and 61. • A ring pattern detection is set (p. 65).
• The TEUFAX mode is set {p. 66-69).
During programming, 1 cannot enter
a code or ID number. • All or part of the numbers are the same. Change the number
(p. 70, 90).
The film runs out quickly. • The HELP button, copy function, and reports use more film.
102
ft