Panasonic KX-FP121NZ - Manual (Page 100)

i Erroii^Messages
Reports
if your unit cannot send a fax, check the following.
- The number you dialed is correct.
- The other party’s machine is a facsimile.
If the problem remains, correct it by following the communication message printed on the sending and journal
reports (p. 51, 52).
Commgnicatiorunessage ^ Error. co(Je. .... ... . .. 1 qu.. 'ГЕЗ* :Qsuse:&Rern^dy^,,j.. .......................... . ^
COMMUNiCATION ERROR 41-72
FF
• A transmission or reception error occurred. Try again or check
with the other party.
DOCUMENT JAMMED — • The document is jammed. Remove the jammed document (p. 108).
ERROR-NOT YOUR UNIT 54, 59
70
• A transmission or reception error occurred because of a problem
with the other party’s fax machine. Check with the other party.
MEMORY FULL — • The document was not received due to memory being full.
NO DOCUMENT — • The document was not fed into the unit properly. Reinsert the
document and try again.
OTHER FAX NOT RESPOND • The other party’s fax machine was busy or ran out of recording
paper. Try again.
• The document was not fed properly. Reinsert the document and
try again.
• The other party’s fax machine rings too many times. To send a
fax manually, dial the number, confirm the fax tone, and press
(START/SET/COPYl.
• The other party’s machine is not a facsimile. Check with the
other party.
• The number you dialed is not in service.
PRESSED THE STOP KEY — • (STOP) was Dressed and fax communication was cancelled.
THE COVER WAS OPENED — • The cover was opened. Close it and try again.
OK — • Fax communication was successful.
Display
if the unit detects a problem, one or more of the following messages will appear on the display.
Displayjnessage "
CALL SERVICE
• There is something wrong with the unit. Contact our service personnel.
CHECK COVER
• The cover is open. Close it.
CHECK DOCUMENT
• The document is not fed into the unit properly. Reinsert the document. If
misfeeding occurs frequently, clean the document feeder rollers and try again
{p. 113). If the problem remains, adjust the feeder pressure (p. 108).
100