Panasonic KX-FT37NZ - Manual (Page 65)

Remote Operation
Operating from a remote location
The following operations can be performed from a remote location using a touch tone telephone.
Set the unit to the TAD/FAX mode before going out (see page 57).
Diai key Remote command Page Dial key Remote command Page
Skips the greeting message 69
Stops re-recording of a greeting
message
68
S) •
Repeats a message 67
sa Erases a specific message 68
® :
Skips a message 67 a® Erases all messages 68
® :.
New message playback 67
®® Changes to the TEL mode 69
am
Turns ON message transfer/pager
call for incoming messages
69
All message playback 67
E ; Re-records a greeting message 68
Turns OFF message transfer/pager
call for incoming messages
69
Remote operation card
Please cut out and carry this card for assistance when using the remote operation.
Answering Device Remote 1
\ Notice of Remote Operation
Operation
1
1. Call your unit.
2. Enter the remote operation ID
I T i'~l during the greeting
message.
* The new recorded messages
will be played automatically.
3. Press the remote command
key(s) (see the reverse side)
within 10 seconds.
If there are no new messages,
press the remote command
key(s) within 4 seconds,
or
Wait for 4 seconds, and all
the recorded messages will
be played back.
• The remote operation is
available only from a touch tone
telephone when the unit is in the
TAD/FAX mode.
• When the unit is in the TEL
mode, call your unit and wait for
15 rings. The answering device
will temporarily answer the line.
Enter the remote operation ID
during the greeting message.
The unit will switch to the
TAD/FAX mode.
0 When you press any key, press
firmly,
• To send a document, press
© d]. When a fax tone is
heard, start transmission.
>
3 '
(ft
€
(b
■ ^
5'
(O
O
<
O
0
65