Installing the recording paper, Note, Installing the paper stacker – Panasonic KX-FT37NZ User Manual

Page 19: Setup

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

■ '•

ite'

Installing the recording paper

Open the cover by pressing the cover open
button and install the recording paper roll.

correct

incorrect

® If the paper is secured with glue or tape, cut

approximately 15 cm (6 inches) from the
beginning of the roll.

Insert the leading edge of the paper into the

opening above the thermal head and pull it out of
the unit.

• Make sure that there is no slack in the paper

roll.

Setup

■0

■O

Close the cover securely by pushing down on
both corners.

Note:
® Only use the included roll of paper or specified recording paper, or else the print quality may be affected

and/or excessive thermal head wear may occur.

• To order recording paper, see page 4.

9 When the power cord is connected, everytime you close the cover a message will be printed. If the recording

paper is set to the wrong side, a message will not be printed. Install the paper correctly.

installing the paper stacker

Install the paper stacker.