Panasonic KX-FT37NZ - Manual (Page 57)

Setup
TAD/FAX mode ------
(using the built-in answering device and receiving voice
and fax calls automaticaliy)
When you turn on AUTO RECEIVE (the pre-selected setting is TAD/FAX), the unit wili work as a facsimile
machine and/or answering device.
if a fax call is detected, the unit will automaticaliy switch to receive faxes.
if a voice call is detected, the answering device will begin recording and the caller can leave a voice message.
® You can use a pre-recorded greeting message (see page 58) or record your own greeting message (see
page 59).
Setting up the voice message and document reception
The total recording time (including the greeting messages) is about 20 minutes. If messages are recorded in a
noisy room, the recording time may be shortened.
To set the unit to record incoming voice messages and receive fax documents, follow the steps below.
1
2
Select “TAD/FAX” in step 4 of feature setting #05
(see page 48).
If the AUTO RECEIVE light is off, turn it on by
pressing [AUTO RECEIVE].
• The unit will play the TAD/FAX greeting message
and the display will show the following message.
Display: TAD/FAX MODE
The remaining time for recording Incoming
messages will be displayed.
Example; TIME = 10ml3s
.3
(Q
a
CD
<
8
Note:
9 Each incoming message recording time can be set to either 1 minute or unlimited. To change the setting, see
page 74.
® When the remaining time is low, erase unnecessary messages from memory (see pages 62 and 68).
» While an incoming call is being recorded, you can monitor it through the speaker. If this feature is not
required, set the ICM monitor feature to “OFF” (see page 75).
57