CANOGA PERKINS 9145ELB NID Software Version 4.01 - Manual (Page 62)

9145ELB NID Software User’s Manual Diagnostics
PING Generation
52
6. To enter the Ping S-VLAN ID, type 6 and press Enter. You can configure this setting only
if the source address (Attribute 2) is Test IP, or Aux IP, and the Aux IP configuration has
the “Allow all VLANs” flag enabled.
7. To enter the Ping Payload Size, type 7 and press Enter. Type a value between 40 and
9950. To send packets greater than 1518 (payload size greater than 1472), the DF (Don't
Fragment) bit must be set or the packet will be fragmented (sent as multiple packets of
size 1518).
8. To change the Ping DF Bit setting, type 8 and press Enter.
9. When you are finished entering values, type 9 to start pinging and press Enter. The PING
test starts (Figure 4-6).
10. When the test is complete, press Esc to return to the PING Generation screen.
Figure 4-6 PING Generation - In Progress screen
Canoga Perkins Corp. Ethernet 1G/10G Network Interface Device 29-AUG-2011
9145ELB-971-4-0 V04.01 10:55:13
-------------------------------PING GENERATION---------------------------------
PING in progress
Ping Address : 0.0.0.0
Ping Count : 0
Ping VLAN Info : C-VLAN ID: 100,
T-VLAN ID: 200,
S-VLAN ID: 300
Pinging 0.0.0.0 from 192.168.92.34 with 40 bytes.
Request timed out, Seq #0
Request timed out, Seq #1
Request timed out, Seq #2
Request timed out, Seq #3
7 packets transmitted, 0 packets received, 100.000% packet loss
round-trip (No round-trip packets received)
Press Escape to continue...
------------------------------------Messages-----------------------------------
-