CANOGA PERKINS 9145ELB NID Software Version 4.01 - Manual (Page 105)

CoS Configuration 9145ELB NID Software User’s Manual
CoS Queues Configuration
95
Figure 9-6 User Port Tagged Packet Classifier Mapping (PCP Mode) screen
4. To map a PCP to a queue on the Network Port, type 2 and press Enter. The Network Port
Tagged Packet Classifier Mapping screen (Figure 9-7) opens.
5. To change the queue setting, enter the PCP number and use the Space bar to select a
queue. Press Enter to confirm the setting. (Only a queue that is enabled can be selected.
To enable or disable a queue, see “Queues Configuration on Network Ports” on
page 101.) Network ports support PCP only.
Figure 9-7 Network Port Tagged Packet Classifier Mapping screen
Canoga Perkins Corp. Ethernet 1G/10G Network Interface Device 29-AUG-2011
9145ELB-971-4-0 V04.01 10:55:13
----------- USER PORT TAGGED PACKET CLASSIFIER MAPPING (PCP MODE) --------------
PCP Queue
--- ---
0 Q1
1 Q1
2 Q1
3 Q1
4 Q2
5 Q2
6 Q3
7 Q3
Select PCP or a Range x-y [0-7]:
------------------------------------Messages-----------------------------------
Canoga Perkins Corp. Ethernet 1G/10G Network Interface Device 29-AUG-2011
9145ELB-971-4-0 V04.01 10:55:13
--------------- NETWORK PORT TAGGED PACKET CLASSIFIER MAPPING ------------------
PCP Queue
--- ---
0 LLQ
1 Q1
2 Q1
3 Q1
4 Q2
5 Q2
6 Q3
7 Q3
Select PCP or a Range x-y [0-7]:
------------------------------------Messages-----------------------------------