Garmin GPS 120 - Manual (Page 63)

Read Only Mem has Failed— The permanent memory has failed and the unit is not
operable. Take your unit to an authorised GARMIN dealer for repairs.
Received an InvaUd WPT— A waypoint was received during upload transfer that has an
invalid identifier.
Receiver has Failed —^A failure in receiver hardware has been detected. If this message
persists, do not use the unit and take it to an authorized dealer for repair.
Route is Full —^You have attempted to add more than 30 waypoints to a route.
Route b not Empty —You have attempted to copy into a route already in use.
Ronte Waypoint Can’t be Deleted— The waypoint you are trying to delete is part of a
route. You must first delete the waypoint from the route before striking it from memory.
Route Waypoint was Deleted —A route waypoint entered does not exist in the database
and has been deleted from the route,
RTCM Input has Failed —DGPS data being received has been lost. You are no longer
receiving the beacon signal.
Searching the Sky —The GPS 120 is in searching the sky for almanac data or the unit is in
AutoLocate™ mode.
Stored Data was Lost —AU waypoints, routes and almanac data has been lost due to
battery failure.
Transfer has been Completed —The receiver is finished uploading or downloading
information to the connected device,
WPT Memory is Full —You have used all 250 waypoints in the GPS 120, Delete unwanted
waypoints to make room for new entries.
55