Emc compliance – Welch Allyn Acuity 6.31.01 User Manual Update - User Manual User Manual
Page 11
Chapter 1 English Update for Acuity System
7
EMC Compliance
Acuity System:
•
Acuity Central Monitoring System (Hardwired and Wireless)
•
Acuity LT Wireless System
•
Acuity LT Hardwired System
The Acuity System complies with all applicable and required standards for
electromagnetic interference.
•
It does not normally affect nearby equipment and devices.
•
It is not normally affected by nearby equipment and devices.
•
It is safe to operate the Acuity System in the presence of high-frequency surgical
equipment.
•
However, it is good practice to avoid using the Acuity System in extremely close
proximity to other equipment.
Guidance and manufacturer’s declaration—electromagnetic emissions
The Acuity System is intended for use in the electromagnetic environment specified below. The customer or the user of the
Acuity System should assure that it is used in such an environment.
Emissions test
Compliance
Electromagnetic environment—guidance
RF emissions
CISPR 11
Group 1
The Acuity System uses RF energy only for its internal
function.Therefore, its RF emissions are very low and are not
likely to cause any interference in nearby electronic
equipment.
RF emissions
CISPR 11
Class A
The Acuity System is suitable for use in all establishments,
other than domestic establishments and those directly
connected to the public low-voltage power supply network
that supplies buildings used for domestic purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations/flicker
emissions
IEC 61000-3-3
Complies