Welch Allyn CardioPerfect Workstation ABP Module - User Manual - Manual (Page 37)

CardioPerfect Workstation
ABP Module - User Manual
DIR 80012332 Ver. E 37 / 40
8. Installing the ABP module
The Welch Allyn Cardio Perfect ABP software module can be used with the following
device:
ABPM 6100:
WA ABP monitor: Welch Allyn, Inc.; Skaneateles Falls, NY, USA
0297
The ABP module is made up of two elements: the recorder, and the software that runs on
the computer to which the recorder is connected. Before you can start recording tests, you
need to:
Connect the recorder to the computer.
Configure the software.
Please refer to the ABPM 6100 hardware manual for instructions on how to handle and
maintain the ABPM 6100 recorder.
8.1 Connect the recorder to the computer
To connect the ABPM 6100 recorder to the computer:
1. Connect the interface cable to the data connector of the recorder. Each time the
cable from the data connector is connected or disconnected, the recorder must be
switched off.
2. Connect the interface cable to your computer.
3. Switch on the recorder.
Note: Please refer to the ABPM Hardware Manual section 3 if your PC has no COM
PORT.
8.2 Configure Welch Allyn CardioPerfect Workstation
After connecting the recorder, you need to configure Welch Allyn CardioPerfect
Workstation.
To configure Welch Allyn CardioPerfect Workstation for use with the recorder:
1. Start Welch Allyn CardioPerfect Workstation.
2. In the File menu, click Settings and click Ambulatory blood pressure.
3. Click the Advanced tab.
4. Select device.
5. Set the COM-port number to the number of the serial port to which the ABP recorder is