Welch Allyn Connex Central Station - User Manual - Manual (Page 25)

Tile-dragging behavior
The following table describes actions in the three tile layout modes. An empty position
on the grid is a blank area with no tiles. An empty room tile represents a room that has
no patient or data assigned to it.
Action Mapped mode Manual mode Automatically sorted mode
Move tiles within the
patient data area to an
empty grid position
Not supported Changes tile position Not supported
Move tiles within the
patient data area to an
empty room tile
Assigns a monitor or a
patient to the new location
Not supported. There are no
empty room tiles in manual
mode
Not supported. There are no
empty room tiles in sorted
mode.
Move tiles within the
patient data area to an
already-assigned tile
Assigns a monitor or a
patient to the location
If a previously assigned tile is
connected to a continuous
monitor, this action assigns
the new device and patient to
the location and moves the
previous device and patient
to the waiting area.
Not supported Not supported
Move tiles from the
waiting area to an
empty position on the
grid.
Not supported The tile moves to the position Not supported
Move tiles from the
waiting area to an
empty room tile
Assigns a monitor or a
patient to the location
Not supported. There are no
empty room tiles in manual
mode
Not supported. There are no
empty room tiles in sorted
mode.
Move tiles from the
waiting area to an
already-assigned tile
Assigns a monitor or a
patient to the location
If a previously assigned tile is
connected to a continuous
monitor, this action assigns
the new device and patient to
the location and moves the
previous device and patient
to the waiting area.
Not supported Not supported
New tile appears,
known location
Tile appears in main tile area Tile appears in waiting area Tile appears in waiting area
New tile appears,
unknown location
Tile appears in waiting area Tile appears in waiting area Tile appears in waiting area
Directions for use Screen elements 19