Welch Allyn TM 262 Auto Tymp - User Manual - Manual (Page 73)

Revised 4/11/08 5-7
RS-232 Interface
217 2 uChar Reflex #1
Result Results of Reflex test #1
Bits 1 & 0 = dB level tested:
00 = Low dB level
01 = Middle dB level
10 = High dB level
11 = Invalid
Bits 3 & 2 = Reflex tests status:
00 = NT = Not Tested
01 =YES = Yes, a reflex was detected
10 = NR = No Reflex detected
11 = NT_CAL = Not Texted due to a
CALibration data error
Bits 5 & 4 = Test frequency:
00 =500 Hz
01 = 1000 Hz
10 = 2000 Hz
11 = 4000 Hz
Bits 6 = Test type:
0 =IPSI
1 = Contra
Bit 7 = Not used
219 4 uint Reflex #1
Baseline
Average Average baseline compliance, in cm 3 X 256
223 4 uint Reflex #1
Reflex Average Average reflex compliance, in cm 3 X 256
227 4 uint Reflex #1
Reflex [0] Reflex compliance data point #1 of 4, in cm 3 X
256.Bit 15 = Noise indicator0 = Quiet data
measurement1 = Noisy data measurement,
potentially unreliable
: : : : :
239 4 uint Reflex #1
Reflex [3] Reflex compliance data point #4 of 4, in cm 3
X256.Bit 15 = Noise indicator0 = Quiet data
measurement1 = Noisy data measurement,
potentially unreliable
243 4 uint Reflex #1
Recovery [0] Reflex recovery compliance data point #1 of
6measured after the stimulus is turned off, in cm
3 X
256,Bit 15 = Noise indicator0 = Quiet data
measurement1 = Noisy data measurement,
potentially unreliable
: : : : :
Character
Number
Number of
Characters
Data
Type
Field Name Field Description