Welch Allyn TM 262 Auto Tymp - User Manual - Manual (Page 47)

Revised 4/11/08 3-13
Operation
If you had previously entered a custom header:
1. Position the square cursor next to the asterisk (‘) in front of Pm Header Custom.
2. Press M+ to display the left-hand margin along the bottom of the display. The word
SAVED will appear at the lower right margin indicating that the custom header is still
selected.
To move the cursor from the left-hand margin without inserting a letter or a number:
1. Select the character that represents a space (i.e., rotate the knob one position to right of the
letter A).
2. Use the > Hz pushbutton to move over to the next character position.
3. Repeat this sequence until the cursor is moved over to the desired start position for the first
character to appear in your header.
4. Rotate the dB HL knob to select the appropriate characters to spell out the desired header.
5. After selecting each character, use the > Hz pushbutton to move over to the next character
position.
6. Once all of the header characters have been added, press the M+ pushbutton to save your
header in memory. The word SAVED will appear on the right-hand margin indicating that
your header is now saved. The square cursor will reappear next to Prn Header Custom.
7. It is now possible to exit the program mode or to sequence on to the next selection.
8. To exit the program mode, press PROG. Enter a single test result and select print screen to
see how the custom header looks.
Audiometric format during printing
The audiometric test results can be printed out in an audiogram format (PRINT -
AUDIOGRAM) or in a tabular format (PRINT - AUD TABLE). The default setting for this
function is the audiogram format.
NOTE: When a specific frequency is deselected for testing, the result will be a break in the
audiogram line at that frequency. This eliminates the assumption that a threshold exists at that
untested frequency.
1. Move the < or > Hz pushbutton to position the cursor in front of the description PRINT -
AUD TABLE.
2. Press the M+ button to save this format as the new default parameter. Note that the word
SAVED appears in the lower right-hand corner of the display to indicate that this new
setting has been saved. With the PRINT - AUD Table selected, all audiometric test results
will appear in a table with the frequency range typed horizontally along the top of the table
followed by two lines of test data. The test results for the right ear will appear next to the
letter R and below each frequency tested. Similarly, the test results from the left ear will
follow below the right ear results.
NOTE: The PRINT - AUD setting selects the format for the printout only. An audiogram
always appears on the screen while in this mode.