Welch Allyn TM 262 Auto Tymp - User Manual - Manual (Page 46)

TM 262
3-12 Revised 4/11/08
To select a different setting for reflex format, note that a square cursor is located next to the
reflex HL + curve option.
1. Use the < Hz button to cursor down to the setting that you wish to select for your own
default criterion.
2. While the square cursor is positioned in front of your desired setting, press the M+ button.
Note that the word SAVED appears in the lower right margin of the screen. Also, this will
cause the asterisk (*) to be deleted from in front of the prior default setting (e.g., Reflex
HL + curve) and to be repositioned in front of the new setting.
Print header format
Three options to choose how the print header will be handled:
• Print header = TM 262
This is the default setting for this feature which means that each time the print screen or
print all tests in memory buttons are pressed, the printout will begin with the label “TM
262.”
• Print header = off
If this option is selected, no header will be printed before any test results, which will save
printout space and printout time.
• Print header = custom
Select this option to design a custom header, which might be the name of your own
facility, department or company name.
Use a similar procedure to that described above to deselect the Welch Allyn header and select
no header or a custom header.
1. With the < or > Hz pushbutton, position the square cursor in front of the desired new
setting
2. Press M+ to select it as the new default setting. The word SAVED appears in the lower
right margin.
If custom header is selected, a line cursor will begin to flash at the left-hand margin below
the words Prn Header Custom. To “type” in the desired header, use the dB HL knob.
Rotating this knob clockwise will sequence you through the alphabet in the forward
direction and rotating this knob counterclockwise will sequence you through the
characters in a reverse direction. The available character set is: A -Z; 0 - 9; and a blank
space. The blank space can be used to erase an unwanted letter or number. A total of 35
character spaces are available.
NOTE: If you want to center the header, it will be necessary to consider the length of the
name to be inserted and calculate from the left margin where you want the header to begin.
Otherwise, if you begin to enter the characters for the header from the left margin, the header
will be printed from the left margin on the printout.