Replacing the covers – Vinten Radamec SP-2000 Pedestal User Manual
Page 78
SP-2000/X-Y
Maintenance And Repair
4-12
User Manual
Replacing The Covers
Install the East and West covers first and then install the North cover.
1.
Have an assistant close by to connect the E-Stop switch harness and colli-
sion bumper harness as you replace each cover. Position the cable to the
back of the gear box as the cover is installed. Take care when installing the
covers to prevent damage.
2.
Install the two screws on the top (5/16” hex key) of the cover.
3.
Install the screw on the side (1/4” hex key) of the cover (two side screws for
the North cover).
4.
Make sure the cover fits correctly and tighten all of the screws.
5.
Install the direction indicator on each wheel and tighten the screw (3/16”
hex key).