Vinten Radamec SP-2000 Pedestal - Manual (Page 14)

SP-2000/X-Y Safety & Introduction
1-4 User Manual
WARNING! - Always set the column to minimum height, turn
power off and engage the two locking pins in the base of the
column before removing the camera or other payload equip-
ment from the head. Or, discharge the gas from the pedestal.
WARNING - NEVER work directly under the camera if the
column is raised. In the unlikely event that the gas pressure
supporting the column is lost, the head and payload may drop
quickly.
CAUTION - NEVER stand under the payload when you
power up the pedestal or switching from Local to Remote on
the MCB Controller. The column may change height quickly.
CAUTION - NEVER attach cables to the head or camera
which could pull the pedestal over if it is moved with the col-
umn extended.
Locking Pin Installed