Vinten Radamec SP-2000 Pedestal - Manual (Page 12)

SP-2000/X-Y Safety & Introduction
1-2 User Manual
Safety Issues
Safety issues including important warnings, risks and related topics are covered
in this section of the manual. It is very important that this information be avail-
able to all personnel who will work on or near the Autocam equipment.
Pedestal E-STOP Switches
3 EMERGENCY STOP switches are located on the top of
each pedestal base. Make sure that all personnel are aware of
the location and operation of these pedestal E-STOP switches
and the main pedestal power down switch before operating
the equipment. Press down firmly on any one of the E-STOP switches to
immediately disable the pedestal and head.
The Off Switch can also be used, but only if the operator can press it quicker that
than one of the E-STOP switches.
After clearing the cause for the emergency stop, twist the appropriate E-STOP
switch clockwise to release it. The pedestal and head can now be powered up
and targeted - see Chapter 2 for operating procedures.
Emergency STOP Switches
(1 hidden)
Pedestal Off Switch