Vinten Radamec SP-2000 Pedestal - Manual (Page 56)

SP-2000/X-Y Installation
3-16 User Manual
Calibrating The Collision Bumpers
Ignore this section if your pedestal has the electromechanical type of bumper.
See page 1-7 if you are not sure which type of bumper you have.
Before the SP-2000/X-Y is put into service it is essential for safety reasons that
the collision bumper detection circuits are calibrated. Each cable skirt (4 total)
has an internal collision detector. All four detectors are connected to the detector
circuit board mounted just below the cable clamp.
Use the calibration procedure in chapter 4.
Collision Bumper Calibration Pots