Vinten Radamec SP-2000 Pedestal - Manual (Page 46)

SP-2000/X-Y Installation
3-6 User Manual
Unloading The Pedestal
1. Twist clockwise on each of the three Emergency Stop Switches to release
them (they will pop up when released).
2. Install the E-STOP bypass jumper plug on the Power/Data In connector on
the control panel as shown below. Without this jumper plug the E-STOP
logic will prevent battery powered operation.
3. The cable skirts around the pedestal base (4 in total) must be raised fully
before you drive the pedestal off the base of the crate and down the ramp.
For each skirt, loosen the thumbscrews, raise the skirt and tighten the
thumbscrews.
E-STOP Bypass Jumper