Mcb controller mounting, Mcb controller mounting –11 – Vinten Radamec SP-2000 Pedestal User Manual
Page 51
SP-2000/X-Y
Installation
User Manual
3-11
MCB Controller Mounting
After the pan/tilt head is mounted, the MCB controller is mounted to a right
angle bar that is attached to the head.
1.
Attach the mounting bracket to the bottom of the head using the four
screws and flat washers provided. Tighten the screws with a 3/16” hex key.
2.
Insert the right angle mounting bar into the bracket and tighten the clamp
screws with a 3/16” hex key. The final positioning of the bar (left/right and
up/down) will depend on the camera position and can be adjusted later.
3.
Mount the MCB controller on the bar and tighten the clamp.
4.
Plug the MCB controller cable into the Local Control Data connector on
the SP-2000 control panel.
Mounting Bracket
Mounting Bar