Vinten Radamec SP-2000 Pedestal - Manual (Page 44)

SP-2000/X-Y Installation
3-4 User Manual
Removing The SP-2000/X-Y From Its Crate
CAUTION: Do not try to push the pedestal off the base of
the crate and down the ramp. You may cause serious electri-
cal and/or mechanical damage.
CAUTION: At least two people are needed to remove the
pedestal from the crate.
As shipped from the factory, the on board batteries of the SP-2000/X-Y are fully
charged. Therefore, unless the dolly is left crated for an extremely long time, it
can be driven off the skid under battery power using the ramp supplied. If you
cannot drive the dolly under its own battery power, the alternate procedure
described below will require the temporary use of the AC power supply and
power/data cable.
Uncrating The Pedestal
1. The shipping crate is re-usable and should be saved for repacking the ped-
estal or should be shipped back to Vinten. Make sure that you retain the
sides, top, ramp, interior brace and the four straps.
2. Release the four straps that hold the crate together by pulling up on the
latch on each buckle. Remove the straps.
3. Using two or more people, lift the top of the crate and set it aside.
Pull Up
To Release