Rice Lake DWM-IV Weighmeter Standard Operators Manual - Manual (Page 14)

SUBTOTAL — The DWM-IV contains ten (10) registers for weight accumulation. The
subtotal of all previously recorded weights or pieces may be recalled and/or printed using
this button. The totals registers remain intact after use.
TOTAL — The totals may be viewed/printed as described in SUBTOTAL above with the
exception that after printing, the current total register is cleared to zero along with the
consecutive numbering register. The current register used for totalizing is selected by this
function.
ID — The ID function allows the operator to enter up to seven (7) digits of numeric ID.
The current value of ID is displayed and may be changed by use of the numeric and
[ENTER] buttons.
CN — The consecutive number may be viewed or changed using this button. The CN is
automatically cleared to zero by totalizing but may be initialized to any value by use of
the numeric buttons. The CN increments before a print cycle begins, as initiated by the
[PRINT] button.
PC WT — This function allows the instrument to be used for piece counting by entering
the known weight per piece. This mode is automatically selected if the current piece
weight register is OTHER than zero. The front panel indicator for PIECES will illuminate
while in the pieces mode. Any of nine (9) different registers may be selected with
different piece weight factors.
Page 12