Rice Lake DWM-IV Weighmeter Standard Operators Manual - Manual (Page 12)

3. [Gross/Net] Button: If a tare has been entered, this button will alternately select
between the gross and net weight modes. If the tare has been cleared to zero, the DWM-
IV will automatically select the gross weight mode. This button will be inactive while the
tare value remains equal to zero.
4. [Print] Button: This button initiates a print cycle to an external peripheral device such
as a ticket printer or computer. The output format may be programmed during the set-up
procedure.
5. [Recall] Tare: The instrument is equipped with a key board to provide a means of
entering a known tare weight. Up to six (6) digits of digital tare may be entered up to the
full capacity. Entries greater than full capacity will be cleared to zero. The least
significant digit (LSD) is automatically rounded to conform to the pre-programmed
instrument LSD. Press the [RECALL TARE] button then a numeric button corresponding
to the tare register desired (if ten (10) tare look-up feature is enabled) and the [ENTER]
button. The previously displayed data will be shown. Enter the required value and press
[ENTER]. This value is then stored in memory. A non-zero value places the system in net
weighing mode.
6. [Select]: This button is used to access the pre-programmed front panel functions as
indicated on the corresponding buttons zero through nine.
7. [Clear]: Used to clear a mistaken entry while in one of the data entry modes.
8. [Enter]: This button is used to store data into memory and also to sequence through the
data entry procedure.
Page 10