Rice Lake BCi Belt Scale - Installation and Operation Manual Version 2.03 - Manual (Page 62)

56 Installation & Operation Manual
6.2 Diagnostics
Diagnostics checks the following parameters to ensure that the outputs are working properly. When pressing the
Diagnostics softkey, the following screen is displayed.
SCALE #1 11/23/2011 08:13AM
mV Input
PPS
Analog Out
A/D Counts
0.710
34
3.0
167.8
Exit =>
235 Master Total
Figure 6-3. Diagnostics Screen
Press the Exit softkey to exit out of diagnostics.
6.3 Reset Totalizer
The operator has the option to clear the totalizer of all data. Select the Reset Totalizer softkey and the user is
prompted Clear Totalizer ? Press Yes to clear the information or No to keep the entered information. If selecting Yes,
the screen prompt says that the Totalizer has been reset .
6.4 Start Fill
The Start Fill softkey starts the fill process and turns on the digital output until the target preact is met. Once the
target preact is met, the on-screen display changes to Stop Fill which turns off the digital output and gives the
operator the Re-Start or Abort softkey.
Pressing Re-Start will resume the fill process.
Pressing Abort will halt the filling process and returns the integrator to normal operation.