Rice Lake 920i Installation Manual V4.01 - Manual (Page 70)

64 920i Installation Manual
6.2 LaserLight Commands
Table 6-2 lists commands to operate the Stop, Go (circle or arrow) and Off display elements on a LaserLight.
These commands are used for front panel softkeys.
Table 6-2. LaserLight Commands
Traffic Light State Aux Fmt Dry Contact Serial Command
Stop AuxFmt1 Dig0 and Dig1 open circuit |00DO3!
Green Circle AuxFmt2 Dig0 open circuit; Dig1 pulled low |00DO2!
Green Arrow AuxFmt2 Dig0 pulled low; Dig1 open circuit |00DO1!
Off AuxFmt3 Dig0 and Dig1 pulled low |00DO0!
6.3 Default Print Formats
Table 6-3 shows the default print formats for the 920i and lists the conditions under which each print format is
used. HDRFMT1 and HDRFMT2 specify header information that can be used by other ticket formats. The
contents of HDRFMT
x can be inserted by using the
Alert Format Commands
Company name (up to 30 characters) All
Contact company address, lines 1–3 (up to 30 characters)
Contact names (up to 20 characters)
Contact phone numbers (up to 20 characters)
Contact e-mail address (up to 30 characters)
Alert error message (system-generated) ALERT
See the iQUBE 2
Installation Manual, PN 106113, for more information about using alerts.
Format Default Format String Used When
GFMT GROSS Normal mode, no tare in system
NFMT GROSSTARENET
Normal mode, tare in system
ACCFMT ACCUM Accumulator enabled and displayed, or
setpoint print operation with PSHACCM=ON
SPFMT Setpoint print operation with PSHPRNT=ON
TRWIN IDGROSS
Press the Weigh In softkey, enter truck ID
number, and press enter.
TRWOUT IDGROSSTARE
NET Press the Weigh Out softkey, enter truck ID
number, and press enter.
TRFMT REG ID: : SCALE Truck register currently displayed
Table 6-3. Default Print Formats
Command Description Supported Ticket Formats
Table 6-1. Print Format Commands (Continued)