ProgressiveRC 6 PowerLab - Manual (Page 79)

79
Troubleshooting
Operating errors appear as safety codes in the display. If possible, correct the error. If
errors continue, contact FMA Customer Service.
Safety Code/Message Problem
Increase Supply NiCd/NiMH charging can’t maintain constant current
Supply <10 Volts Supply voltage is too low
Supply >32 Volts Supply voltage is too high
Supply Unstable Check connections. Increase wire size to charger
Preset not 6S Preset is meant for a different charger
Bad Preset Version Preset has a bad version number
NiCd Amps Hi Temp NiCd/NiMH charging can’t maintain constant current. Reduce charge current
Series Chargers Check the battery output. Make sure the pack is not in series with another pack.
P. Library Empty No presets are in the library
Low Voltage Cell A cell is too low
Preset is Hidden A hidden preset is trying to run
Reverse Polarity Check the output pack
Preset is Empty Preset will not run on charger
ENTR not Pressed The chemistry has not been confirmed
System Softstart Check the power supply connections. Check the PL6 input current limiting
Preset is Locked Locked presets can not be changed
Cell No Add Up Check the node connector and adapters.
Max Cells Error The unbalanced cell limit has been exceeded
No Pack A pack has not been detected
Bad Cell Count
Check the node wires and adapter. Check that the proper node wiring
configuration is selected (XH or FMA)
Lost Data Link Slave charger has an error
Cells Exceeded The maximum allowed number of cells has been exceeded
Un-Bal Only The node wire shouldn’t be connected in unbalanced charging
Charge Timeout The maximum charge time has been exceeded
Cell Cnt Changed The cell count has changed. Check the pack
NiCd Detected A NiCd/NiMH pack has been detected in another chemistry
Wrong Cell Count Check the node wiring and/or selected node type (XH or FMA)
Sply V. down 37% The supply voltage has dropped too much
Sply < Low Limit The supply voltage is less than the low limit set point.
Options Corrupt The options checksum is bad. Factory Restore the charger.
Hi node V.Drop Node only charging has a high voltage drop. Check the wiring.
Node Over Amps Check the wiring
1 Primary Only Check the charger addresses
ERROR ON EXP. CH One of the slaves has stopped
ERROR ON PRIMARY The master charger has stopped
Banana Over Amps Check the wiring for a loose connection. Check the supply wiring too.
WDT System Reset Check the supply wiring
SVS System Reset Check the supply wiring