Using the charge control software, About the ccs, Charge control software – ProgressiveRC 6 PowerLab User Manual
Page 37
Using the Charge Control Software
About the CCS
The free PowerLab 6 Charge Control Software (CCS) gives you unparalleled ability to customize the PowerLab 6.
In order to connect the PowerLab 6 to the computer and use the CCS, you are required to use one of the FMA PC
USB Interfaces; either the FUIM2 or the FUIM3.
This table lists common CCS tasks. What do you want to do?
To do this...
Go here...
Download and install the Charge Control Software
Monitor pack voltage, cell voltage and other data during
charging
Cells
tab
Initiate and control charging from CCS
Cells
tab
View charge data in real-time graphs
View > Graphs
command
Change graph update interval
View > Preferences > Graphing Update
Rate
command
View cell internal resistance during charging
Int. Res.
tab
Monitor supply voltage and current during charging
Supply
tab
Specify default power source type, and set power source
operating parameters
Supply
tab
Update PowerLab 6 firmware
Firmware
tab
Update Library Presets
Firmware
tab
Restore factory User Presets
Firmware
tab
Configure, save and load PowerLab 6 options
Options
tab
Modify User Preset parameters
Presets
tab
Show, hide, reorder, save and load presets
Presets
tab
Correct preset errors
Errors
tab
Generate a custom fuel table (Fuel Wizard)
Tools > Generate Fuel
command
Run multiple CCS instances
37