ProgressiveRC 4010Duo iCharger - Manual (Page 5)

iCharger Synchronous Balance Charger/Discharger 4010DUO
- 5 -
transfer, sub-license, as well as other acts of infringement of software copyright is strictly prohibited, but apart from
the restrictions prohibited by applicable law.
 4010DUO Special Features
1. The 4010DUO uses advanced Synchronous buck-boost DC/DC converter technology, high power, a high current
and high-performance power conversion circuit. The maximum charge power capacity is up to 2000W, the
maximum charge/discharge current of a channel is up to 40A, and two channels in Synchronous Mode are up to
70A.
2. Channel Supports 10s LiPo, Lilo, LiFe, NiZn, with maximum 1.2A balance current, and adopts a unique balance
calculation of internal resistance correction.
3. Intelligent fan control. Sensing internal temperature via the internal temperature sensor, to thereby control the fan
speed.
4. When the channel output connects the battery after the charger powers on, it will start automatically the
anti-sparking protection (the chargers with V2.05 above firmware version) .
5. Internal temperature protection. When the internal temperature exceeds the Power Reduce temperature, the output
power is automatically reduced; and the charger will shut down when temperature exceeds the Shut-down
temperature.
6. This charger can save 64 parameters sets and support the data import/export to SD card.
7. A 2.8-inch LCD screen provides rich information including current, voltage, power, capacity, internal resistance,
control status, time-consuming and temperature, etc.
8. Multi-discharge features: self-discharge, regenerative to input discharge, regenerative to channel discharge, and
lithium battery extra expanding discharge.
9. Supports measurement for internal resistance of battery offline and online. Can measure not only the internal
resistance of the entire battery pack, but also measure the internal resistance of each cell within the lithium battery.
10. The iCharger has protection for reversed polarity (input or output), input voltage/current, battery temperature,
charging capacity, overrun time and maximum power etc.
11. Supports upgrading the hardware program by USB port. The iCharger also supports the “Logview” software and
can display, plot and analyze the charge and discharge data by it. (See detail information about Logview at the
following website: http://www.logview.info)
 Appearance Parameters
Net weight: 1.47kg
Dimension: 210.0Ч140.1Ч80.2 ±0.5mm
 Specifications
Input voltage range: 9.0—50.0VDC
Maximum input current limit: <65A
Maximum charge/discharge current: 70A@Syn. Mode 40A@Asyn. Mode
Maximum charge power capacity: 2000W (Channel 1400W @input > 23.5V)
Maximum discharge power capacity: 200W (Channel 130W)
Maximum regenerative discharge power capacity: 2000W (Channel 1400W)
Maximum extra discharge power capacity: 3200W (Channel 1600W @40V/40A)
Maximum current drain for balancing: 2.4A@Syn. Mode 1.2A@Asyn. Mode