ProgressiveRC 4010Duo iCharger User Manual

Page 28

iCharger Synchronous Balance Charger/Discharger

4010DUO

- 28 -

 Beep Tone Setup

Select SYSTEM MENU→Charger Setup→Beep Tone to enter the setup interface.

Note: Tick the appropriate tone, and then go to Volume adjustment bar to adjust the volume; If the

beep tone is not ticked the corresponding volume adjustment shows inactive; Done Beeps have
many styles available, in sequence number 5 above.

 LCD Setup

Select SYSTEM MENU→Charger Setup→LCD Screen to enter the setup interface.

 Output Power Setup

Select SYSTEM MENU→Charger Setup→Output Power to enter the setup interface.

Note: The maximum power limit for regenerative discharge is equal to the maximum power limit for

charge.

When the input or output power of charger is limited, it will trigger the CH-1/CH-2 Channel

Partiality.

When Partiality switches to Same, charger assigns the output power equally to two channels,

switch to CH-1 or CH-2, the charger will give priority to the selected channel output, while the
output power of other channel may be reduced to 50W (discharge for 5W).

1: Brightness adjustment

2: Contrast adjustment

1/2: CH-1/CH-2 Output Power Setup

Charge: Maximum Power Limit for charge

5W-1400W; default: 1400W

Discharge: Maximum Power Limit for discharge

5W-130W; default: 130W

3: CH-1/CH-2 Channel Partiality Selection

Same (default), CH-1, CH-2

1: Key Tone 2: Hint Tone

3: Alarm Tone 4: Done Beeps

5: Volume adjustment display

Beep 5times (default)

Beep 30second

Beep 3minutes

Beep always

6: Program Done Beep Tones Selection

7: Reduced sensitivity knob

1
2
3
4