Entering destination via the map, Navigation, Destination input – Mercedes-Benz C-Class 2010 COMAND Manual User Manual
Page 71
X
To select a destination: Rotate
y
m
z
or
slide
q
m
r
.
X
To confirm selection: Press n.
X
To start route calculation: Select Start.
i
For more information on the “Last
Destinations” memory go to
(
Entering Destination via the Map
i
In some countries, entering destinations
via the map is not possible at vehicle
speeds above apprx. 3 mph. The function
becomes available again as soon as the
speed falls below apprx. 2 mph.
Using the destination entry via the map,
you can also enter a destination that lies
within the digital map but whose address
data is not included in the digital map.
Opening the Map
X
If at least a city has been entered, select
Map in the Enter Destination menu
(
or
X
If necessary, display the menu system in
the map display (
X
Select Destination£Using Map.
In both cases, the map together with
crosshairs appears.
1
Current vehicle location
2
Crosshairs
3
Information on crosshairs position
4
Set map scale
i
The display 3 depends on the settings
selected in “Information On Map”
(
page 57). It may display the current road
if corresponding data is available in the
digital map. Or it displays the geo-
coordinates position of the crosshairs if
Geo-coordinates display is activated
and if there is adequate GPS reception.
Moving the Map and Selecting a
Destination
X
To move the map: Slide
q
m
r
,
o
m
p
or
w
m
x
.
X
To set the map scale: Rotate
y
m
z
.
Rotating clockwise makes the map smaller,
rotating counterclockwise enlarges it.
X
To select a destination: Press n once or
repeatedly until you get a list of
destinations if available.
X
To select a destination: Rotate
y
m
z
or
slide
q
m
r
.
X
Press n.
If the destination is within the digital map,
COMAND tries to find the destination on
the map.
If the destination can be found, the Enter
Destination menu is displayed with the
Destination Input
69
Navigation
Z