Mercedes-Benz C-Class 2010 COMAND Manual - Manual (Page 161)

Wireless Headsets
:
Setting the volume
;
Selecting the display screen
=
Battery compartment
?
Switching headset on/off
A
State Indicator LED
X Adapt the fit of the headset by pulling the
headset clamp as indicated by the arrows
in the figure above.
Switching ON/Off the Wireless headset
X Press button ?.
Depending on the previous state the
headset is switched on or off. In order to
preserve battery charge, the headset is
switched off if there is no IR signal
reception for appr. 3 minutes.
Setting the Wireless Headset Volume
X Turn the Thumb wheel : to set the desired
volume.
i If you have connected a wired headset to
a display screen, you can set the volume
with the button : of the remote control
(
Y page 157).
Selecting the Display Screen for the
Headset
X Rotate the wheel = until L or R appears in
the small window.
State Indicator LED
The color of the LED indicates:
R
if the headset is switch on or off
R
the battery condition
Color State
Green Headset is switched
on and the batteries
are full.
Dark Headset is switched
off or the batteries
are empty or not
inserted.
Red Headset is switched
on and the batteries
are almost empty.
Connecting Additional Headsets
You can connect wired headsets to both of
the display screens. The socket is suitable for
headsets with 1/8“ stereo jacks and 32
Ohm
impedance ( Y page 157).
Rear Compartment Socket
In vehicles with the rear-seat entertainment
system, there is a 12
V socket in the rear
compartment on the center console.
The socket can be used for accessories with
a maximum power consumption of 180
W.
General Information
159
Rear Seat Entertainment
Z