Losi LOSB9811 - Manual (Page 2)

5. Do not use the internal radio charge circuit or connection; remove the
battery for charging and follow charging instructions.
6. If you’re using LOSB9605 balance charger, you should connect the balance
plug to the charger.
7. Do not leave battery unattended while charging.
8. With your LiPo transmitter battery pack properly charged, you are ready for
installation.
Installation:
1. Using your radio manufacturer’s instructions, remove your current transmitter
battery.
2. Examine and note the polarity of the Transmitter Power Connector (refer to
the manufacturer’s manual).
3. Looking at the LOSB9811 transmitter battery, notice that the RED wire is the
Positive lead and the BLACK wire is the Negative lead on the connector.
Please see, in picture below of an M11 Transmitter, the Positive (+) is the center
position of the transmitter connector, and the Negative (-) is located on either
side of the connector.
With the LOSB9811 transmitter battery in hand, plug the battery into the
transmitter connector.
4. Please note that you may want to insert a piece of soft foam material on
either side or at the end of the battery to prevent the battery from moving
around in the transmitter.