beautypg.com

Losi LOSB9811 User Manual

Losi Hardware

background image

Losi (LOSB9811) 2400mAh 11.1V LiPo Transmitter Battery for

Airtronics M11, MX-3, and Other Radios

of Similar Battery Configuration

User Manual

Safety Precautions:

1. Read all safety precautions prior to use.
2. Always check and ensure polarity during installation or re-installation of

battery into your transmitter.

3. Charge ONLY as a 3-cell (11.1V) lithium battery (LiPo) or may cause fire.
4. Re-charge transmitter battery when Transmitter is at 11.1V Do not allow

the battery to discharge below 9.6V.

5. This battery has protection circuitry that monitors the status of each cell to

ensure safe charging. Charge with a LOSB9603, LOSB9605 or Dynamite

DYN4058 LiPo charger. Cell balance is maintained only when used with a
balancing charger such as LOSB9605.

6. Do not use the internal radio charge circuit or connection; remove the

battery for charging and follow charging instructions.


Charging the LOSB9811 Transmitter Battery:

1. Read all safety precautions prior to charging.
2. There are two different connectors (see picture below).

a. White connector is used for Balance Charging the 3-cell LiPo

battery.

b. The Red (darker above) is the Primary Charge/Discharge connector.

3. Set your LiPo charger to the 3-cell position for 11.1V, and no more than 2.4A

for the charge rate. Do not charge at more than 1C charge rate (2.4A for
LOSB9811 which is 2400mAh battery). Exceeding this may cause the product
to ignite.

4. Connect the RED plug with your charger.