Losi LOSB9500 User Manual
Page 6
Xcelorin Software upgrade to Version 2 Page 6 of 6
To select the different profiles without PC Software:
Did you know that you can Write to Profile 4 and 5? Then using the steps below
retrieve them into the active profile at the track
1. Turn the Transmitter on.
2. Turn the vehicle on.
3. With the ESC turned on and ready for operation press and hold the setup button
until both the Yellow and Blue LEDs turn on.
4. Release setup button.
5. The status LEDs flash to indicate the current profile setting.
LED status for each Profile below:
Profile 1 Yellow and Blue LEDs flash
Profile 2 Yellow, Blue and Green LEDs flash
Profile 3 Yellow, Blue, Green and Red LEDs Flash
Profile 4 Red and Blue LEDs flash
Profile 5 Yellow and Green LEDs flashing quickly
6. To make a change, quickly press the setup button, which will advance you to the
next profile.
9
7. When you are finished, press and hold the setup button for 2 seconds the four
status LEDs will scroll and the new selection will be stored to the active memory of
the ESC.
8. If you do not press the setup button within 15 seconds, the four status LEDs will
scroll to indicate you are exiting programming. The ESC will return to neutral and be
ready for use without any change.