Losi XXX-S Sport - Manual (Page 7)

26
28
27
24
9
23
25 22
21
Step B-2
q 1. Snap a 3/16" x 3/8" Bearing (25) into the right side of the Idler
Pulley (23). The Bearing will snap past the ridge in the Pulley and
stop.
q 2. Place the Idler Pulley Shaft (22) through the Idler Pulley from
the Bearing side.
q 3. Slide a #4 x .020 Washer (9) over the 4-40 x 5/16" Button Head
Screw (24).
q 4. Insert the 4-40 x 5/16" Button Head Screw through the Idler
Pulley Shaft and secure it to the Belt Tensioner Arm (21) as shown in
Figure 10.
Figure 11
Figure 10
BAG B
4
9 25 24 22
*NEVER PINCH THE BELT*
Pinching the Belt can reduce the life of the Belt.
q 1. Position the Chassis (27) upside-down on your work bench.
Insert the Belt (26) and pull it through both ends of the Chassis.
q 2. Pull the Belt out, just slightly, through the bottom of the Chas-
sis and insert the Steering Tunnel (28), tall end forward, into the slot
in the front of the Chassis. Press into position as indicated in Figure
11.
The Steering Tunnel should now be located in between the
Belt, with the Belt still slightly hanging out of both ends of the car.
Step B-1
*NEVER PINCH THE BELT*
NEVER OVER TIGHTEN THE SCREWS IN THE CHASSIS - Team
Losi has designed interlocking features into the XXX-S chassis, when
screws are to the point of being snug the parts are held firmly in place.
Idler Pulley to Belt Tensioner
Belt Installation