Losi LST XXL Getting Started Guide User Manual

Getting started

GETTING STARTED

NOTE:

Before you start running your LST XXL™, read your engine break-in and operating
instructions. If you run your LST XXL without following proper break-in procedure,
you may damage or fail to get maximum performance from your engine, and void the
warranty.

O-ring

end.

Page 1

Install the 4 AA-size alkaline batteries in the transmitter
making sure the positive (+) and (-) negative ends are
oriented correctly.

Using the charger of you choice, follow the manufactures
instructions and charge the receiver battery pack mounted in
the chassis. (fig. 2A). After the pack has been charged plug the
battery into the switch harness (fig. 2B).

Receiver Battery

You will need to purchase a 7.2v six cell battery pack (fig. 3A) for the Spin-Start. Using the charger of your choice
follow the manufactures directions to charge this battery pack. Slide the battery access panel opposite the hand
strap back and remove the cover. (fig. 3B) Remove hex starter shaft from the back side of the cover (fig. 3C) and press
the O-ringed end into the drive cup. Slide a charged 7.2-volt 6-cell “stick pack” (not included) into the Spin-Start
and plug it in. Note that the plug is made such that it can only be plugged in one way. Carefully tuck the plug wires
under the battery access panel and slide shut.

Radio Batteries

Spin-Start Battery Installation