Losi LOSB0085 Getting Started Guide - Manual

Page 1
Radio Batteries
Install the 4 AA-size alkaline batteries (included) in
the transmitter making sure the positive (+) and (-)
negative ends are oriented correctly.
GETTING STARTED
Before you start running your LOSI ® 8IGHT-T 2.0 ™ RTR read your
engine break-in and operating instructions. If you run your
8IGHT-T 2.0 RTR without following proper break-in procedure,
you may damage or fail to get maximum performance from your
engine, and void the warranty.
NOTE:
Receiver Battery
Unscrew the two 4-40 screws and remove the two
body clips from the battery box on your 8IGHT-T
2.0 RTR. Here you will find your receiver battery
pack. By using the charger of your choice, follow the
manufacturers instructions and charge the receiver
battery pack (fig. 2A). After the pack has been charged
plug the battery into the switch harness (fig. 2B).
Fig 1
Fig 2A
Fig 2B