Bag c (continued) – Losi XXX-S Sport User Manual
Page 13
27
55
56
37
49
BAG C (Continued)
Step C-5
Figure 23
WIDE
NARROW
Figure 22
10
q
1. Use Figure 22 to determine how the Servo Mounting Posts
(55), (56) should be attached to the servo (not included) in the Wide
or Narrow position.
q
2. Place a #4 Hardened Washer (37) over each of the four 4-40 x
3/8" Button Head Screws (49) and attach the Servo Mounting Posts
to the servo by threading the Screws through the servo mounting
ears into the Upper and Lower holes in each Post. Do not tighten the
screws yet! Just snug them up so that the posts are held in place, but
can still be moved from side to side with a little resistance.
q
3. As shown in Figure 23, you will use the Chassis to determine
the exact spacing needed for your brand servo. With the Screws still
loose, push the Pins on the Servo Mounts into the holes in the bot-
tom of the Chassis (27). Slide the mounts until the Screws are cen-
tered on the servo, and tighten as indicated in Figure 23.
The servo should be as close to centered between the two Posts
as possible.
37
49
AIRTRONICS
ALL
FUTABA
FUTABA
S3401, S9402, S9404, S9450
HiTech
ALL
JR
JR
Z4750, Z8450
KO
PS-702, PS-703, PS-1001, PS-1003
KO
PS-901BH, PS-902
MULTIPLEX
ALL
NARROW
23
WIDE
NES-507, NES-513, NES-517, NES-901, NES-4000,
NES-4131, NES-4721, NES-4735, NES-9021, DS-
23
23
23
23
WIDE
WIDE
NARROW
NARROW
SERVO TYPE
OFFSET
NARROW
NARROW
NARROW
23
24
25
REQUIRED
SERVO ARM
S131, S131SH, S148, 23001, S3003, 25101, S9101,
S9201, S9304, S9401, S9403
25
Table 22
Servo Mount Install